Medium voltage cable buyer in Orangeburg, SC
Medium voltage cable here comes off mill substations and distribution yards: shielded, tape or wire, with a stress cone at each end and a splicer’s tag if you are lucky.
- Orangeburg County
- I-26 and US-301
- 5 kV to 35 kV
Medium voltage cable in Orangeburg
Medium voltage starts where building wire stops, at 2,000 volts and up. In practice most of what moves through this market is 5 kV, 15 kV and 25 kV, shielded, with insulation of EPR or XLPE and a metallic shield over it. It is heavy, it is stiff, and it is the one cable in a plant that nobody moves without a reason and a plan.
It is also the most documented cable in the building. A medium voltage feeder has test records, a splicer’s name, a pulling log and a set of termination details. When a substation is retired, that documentation is what separates a length that can be reused from a length that is scrap with a thick jacket. The cable may be sound and still be unreusable without its history.
Orangeburg County’s electrical infrastructure was built around its mills and the distribution sites that served them. Substations sit at the edge of plants, fed overhead or by duct bank, and the cable between transformer and switchgear is often the last thing removed and the first thing forgotten. It lives in a fenced yard or a locked room, not on a shelf.
The material sits along I-26 and US-301, in industrial sites strung between the town and the interstate. Some of it is in duct bank, which means it comes out in pulls and is measured by the duct run. Some is on rack at 5 kV. Condition depends on whether the cable was de-energised properly, discharged, and left with its ends sealed.
Why this material gets reviewed properly
Documentation is part of the material
A reel of 15 kV cable with a test sheet, a date and a length is a different asset from the same cable with nothing. Without records it can still be reviewed, but the basis will assume testing before reuse, and that assumption is priced in. A seller holding the substation file should say so early.
Handling is not a one person job
Medium voltage cable is stiff, heavy and easily damaged by a tight bend. A coil wound below its minimum bend radius has a question over the insulation that no photograph will answer. We ask how it was coiled, what it was coiled on, and whether it was dragged over an edge getting out of the building.
The ends tell the story
A sealed end with a cap or a taped boot suggests the cable was decommissioned with care. An open end, a protruding conductor and a stress cone cut off with a knife suggests it was removed in a hurry. The first few inches at each end say more about the history than the middle of the run does.
Related wire types
Questions on this material
Do you handle cable that is still energised?
No. Nothing is touched until the circuit is isolated, locked out and proven dead, and the cable has been discharged. Medium voltage cable holds a charge after isolation, and that is a job for the site’s own electrical staff under their own procedures. We arrive after that, not before.
What records make a difference?
A test sheet with dates, a pulling record with lengths, and the cable’s own print showing voltage class and insulation type. Splicer records help where joints were made. Where none of that exists the review proceeds on the print and the physical condition, and the basis will say the cable is untested.
Can you take cable still in a duct bank?
Yes, as a pulling job, which is a different exercise from collecting a reel. It needs the duct route identified, the ends exposed, and a winch or puller on site. The length is known from the duct run rather than measured afterwards, which is an advantage. We will want the route before quoting.
Is 5 kV reviewed the same way as 15 kV?
The process is the same; the market is not. Lower voltage cable has more potential users, including plants with older distribution, while 15 kV and 25 kV are more specific. The voltage class is read from the print and from the insulation thickness, and it sets both the description and the basis.
Send medium voltage cable details
Pickup is in Orangeburg. Include condition, footage and how the material is stored.
Or email saleselectricalbuyers@gmail.com
- No fee and no obligation to sell.
- Written lot terms before anything moves.
- Pickup scheduled around your access rules.