Submersible pump cable buyer in Greenville, NC
Pump cable comes out of eastern North Carolina wells wet, silted and cut at the splice. We review it on conductor size, jacket integrity and how much of the drop length actually survived.
- Pitt County
- US-264 and I-587
- Well and washdown pulls
Submersible pump cable in Greenville
A submersible pump cable is an odd piece of inventory. It lives underwater, inside a well casing, for years, and then arrives at a bench in three pieces with a splice kit still bolted to one end. Around Greenville the cable is flat jacketed, two or three conductor, usually 12 or 10 gauge, feeding a 230 volt single phase pump in a domestic or irrigation well. What a buyer wants to know is whether the jacket is still round and what the drop length was.
Food processing adds a second stream. Washdown bays, chill water and packing lines use pump cable in wet locations where the jacket meets caustic cleaners and hot water instead of well water. That cable ages differently, going hard and chalky before it fails at a bend. Both kinds are worth reviewing. Neither should be tipped into a pile with building wire, because the jacket and the fine stranding change how the lot is weighed, coiled and described.
In Pitt County the material sits wherever the water is. Farm shops out along NC-33 and NC-11 hold pulled pumps and coiled drop cable waiting on a decision, and packing houses near the US-264 corridor keep a spare length on a shelf beside the contactors. The washdown side of it lives in the industrial buildings closer to town. None of this looks like a warehouse of new reels. It looks like a bench, a bucket and a length of cable with a taped end.
The condition is usually the same story. Cable pulled from a well is wet, iron stained and silted, and cut short at both ends where the splice and the pump connection were made. Cable from a washdown room is dry but stiff, with the jacket checked at every bend. A photograph of the jacket print tells us more than a paragraph of description, because the print carries the gauge, the conductor count and the temperature rating.
Why this material gets reviewed properly
The drop length decides the review
A pump cable’s usefulness sits in its length. A fifty foot tail pulled from a shallow well is a remnant. A continuous two hundred foot drop with the jacket intact is a usable length even after years in the ground. We ask for the measured length rather than the reel it came on, because pump cable is almost never on a reel by the time it reaches a shop floor.
Water damage is not automatically scrap
Wet cable is normal for this material and is not a defect by itself. What downgrades it is ingress under the jacket, a swollen or split jacket at the splice, or a ground conductor that has gone green through the strand. We will look at a clean wet length and a silted one differently, and we will tell you which one we think we are looking at.
Mixed with building wire it loses its name
Pump cable thrown into a box with THHN cut-offs becomes a mixed lot and gets reviewed as one. Kept separate, with the gauge and conductor count visible, it stays a named item with a length attached. The separation costs a few minutes and changes how the lot is described on the written basis.
Related wire types
Questions on this material
Do you buy pump cable that has been down a well?
Yes, and that is the normal condition for this material. Pulled cable is wet, often silted, and usually cut at both ends. We review it on measured length, conductor size and jacket condition rather than on appearance. Send a photograph of the jacket print and the cut ends with a measured length, and the review can start.
How is the length measured when the reel is long gone?
By hand along the ground, or by weighing a known conductor size against a footage chart. Pump cable is flat and consistent, so weight per foot is a reliable check. We will accept your measurement and then verify it. What we will not do is guess a length from the diameter of a coil in a photograph.
What about the splice kit and arrestor still bolted on?
They come off. Fittings, splice kits and torque arrestors are not part of the cable review and are not valued. Cut them away before measuring if you want a clean number, or leave them on and we will note that the length includes hardware. Either is workable; the note matters more than the hardware.
Can you collect from a farm shop outside Greenville?
Yes, provided the access suits the vehicle. A farm shop with a gravel drive and a roll-up door is often easier than a loading dock. We ask about gate width, overhead clearance and whether a trailer can turn around. Small lots travel as LTL; larger ones go on a flatbed.
Send submersible pump cable details
Pickup is in Greenville. Include condition, footage and how the material is stored.
Or email saleselectricalbuyers@gmail.com
- No fee and no obligation to sell.
- Written lot terms before anything moves.
- Pickup scheduled around your access rules.